Ingenieria Grupo Empresarial Actual S.A. De C.V.

Mark 3 ANSI Standard

Mark 3 Lo-Flo

Mark 3 Unitized
Self-Primer

Standards
• ASME (ANSI) B73.1
Operating Parameters
• Flows to 1680 m3/h (7400 gpm)
• Heads to 215 m (700 ft)
• Pressures to 27 bar (400 psi)
• Temperatures from -75°C (-100°F)
to 370°C (700°F)
Features
• Exclusive reverse vane impeller
• Standard Mark 3A power end
– External micrometer impeller
adjustment
– Double row angular contact outboard
bearings
– Single row, deep groove inboard
bearings
– Double lip oil seals
– Constant level oiler
– Large, reflective sight glass
• Choice of lubrication systems
• Optional ANSI 3A power end with
lifetime warranty
– Certified clean room assembly
– Inpro/Seal’s VBXX isolators
– Magnetic drain plug
• SealSentry™ seal chambers
• Largest shaft and bearing components
in standard ANSI pumps
Other Configurations
• Mark 3 Lo-Flo
• Mark 3 unitized self-primer
• Mark 3 recessed impeller
• Mark 3 Sealmatic dynamically sealed
See Bulletin PS-10-13

Standards
• ASME (ANSI) B73.1
Operating Parameters
• Flows to 50 m3/h (220 gpm)
• Heads to 300 m (1000 ft)
• Pressures to 30 bar (450 psi)
• Temperatures from -75°C (-100°F)
to 370°C (700°F)
Features
• Circular, concentric casing
• Radial vane impeller
• Mark 3A power end
– External micrometer impeller
adjustment
– Double row angular contact outboard
bearings
– Single row, deep groove inboard
bearings
– Double lip oil seals
– Constant level oiler
– Large, reflective sight glass
• Choice of lubrication systems
• Optional ANSI 3A power end with
lifetime warranty
– Certified clean room assembly
– Inpro/Seal’s VBXX isolators
– Magnetic drain plug
• SealSentry seal chambers with
flow modifiers
• Oversized shaft and bearing
components
See Bulletin PS-10-13

Standards
• Flowserve
Operating Parameters
• Flows to 320 m3/h (1400 gpm)
• Heads to 120 m (400 ft)
• Pressures to 20 bar (285 psi)
• Temperatures to 370°C (700°F)
• Static suction lift to 6 m (20 ft)
Features
• Unitized casing with large priming
chamber, air separator and volute
• Exclusive reverse vane impeller
• Mark 3A power end
– External micrometer impeller
adjustment
– Double row angular contact outboard
bearings
– Single row, deep groove inboard
bearings
– Double lip oil seals
– Constant level oiler
– Large, reflective sight glass
• Choice of lubrication systems
• Optional ANSI 3A power end with
lifetime warranty
– Certified clean room assembly
– Inpro/Seal’s VBXX isolators
– Magnetic drain plug
• Oversized shaft and bearing
components
Other Configurations
• Mark 3 recessed impeller, self-primer
See Bulletin PS-10-13