Ingenieria Grupo Empresarial Actual S.A. De C.V.

FRBHJC
Cantilever Sump

MJ and MJC Hard Metal
Slurry Sump

RJ and RJC Rubber Lined
Slurry Sump

Standards
• Flowserve
Operating Parameters
• Flows to 2700 m3/h (12000 gpm)
• Heads to 100 m (325 ft)
• Temperatures to 150°C (300°F)
• Speeds to 1780 rpm
Features
• True stiff shaft cantilever design,
without bottom bearing or
flushing water
• Steep head capacity
• Semi-open, full vane impeller with
back pump-out vanes
• Stuffing box accommodates multiple
seal types
• Direct coupled or V-belt driven
• Extra heavy-duty alloy steel shaft
Other Configurations
• FRBH heavy-duty paper stock
and process
• FRBHJ vertical lineshaft sump
See Bulletin PS-10-16

Standards
• Flowserve
Operating Parameters
• Flows to 225 m3/h (1000 gpm)
• Heads to 30 m (100 ft)
• Pressures to 10 bar (150 psi)
• Temperatures to 110°C (225°F)
• Solids from 2% to 70% by weight
• Speeds to 1780 rpm
Features
• MJ - Submerged bearing and
lineshaft design for deep setting
• MJC - Cantilever design with no
submerged bearings
• Abrasion and corrosion-resistant high
chrome iron concentric casing
• Integrally cast straightening vanes
in the suction nozzle
• Closed impeller with pump-out vanes
on front and rear shrouds
• MJ has fluted “Cutlass” rubber
bearings
• MJC has “Thordon” restriction
bushing
• Directly coupled or V-belt driven
• Options
– Hard metal expeller
– Open and recessed impellers
– Choice of materials
Other Configurations
• M horizontal hard metal
abrasive slurry
See Bulletin PS-10-19

Standards
• Flowserve
Operating Parameters
• Flows to 225 m3/h (1000 gpm)
• Heads to 30 m (100 ft)
• Pressures to 10 bar (150 psi)
• Temperatures to 110°C (225°F),
depending on material
• Solids from 2% to 70% by weight
• Speeds to 1780 rpm
Features
• RJ - Submerged bearing and lineshaft
design for deep setting
• RJC - Cantilever design with no
submerged bearings
• Radially split casing with antiprerotation
vanes in suction nozzle
• Casing liners pressure molded
on steel backing plates
– Multiple materials available
• Pressure molded rubber closed
impeller with pump-out vanes on front
and rear shrouds
• RJ has fluted “Cutlass” rubber
bearings
• RJC has “Thordon” restriction
bushing
• Directly coupled or V-belt driven
• Options
– Hard metal expeller
– Choice of liner materials
Other Configurations
• R horizontally split rubber
lined slurry
See Bulletin PS-10-18